Stadler Form Lucy Black Aroma Diffuser

Only use a power adapter with the following specifications: DC 5V / 2A

Make sure that the LED dimmer is deactivated (press the right-hand button on the front several times: normal – dimmed – switched off).

If there are limescale deposits on the membrane, Lucy’s mist may be less distinct or less powerful. If that is the case, you can clean and descale your Lucy thoroughly, paying particular attention to the membrane. We recommend wiping the membrane carefully with a cotton bud soaked in descaler until all the limescale has gone. Under no circumstances should you attempt to chip limescale deposits off the membrane using a hard or pointed object!

After cleaning, rinse thoroughly with clean water. Make sure that no water gets into the air outlet opening during cleaning or rinsing.

Only use a power adapter with the following specifications: DC 5V / 2A

No, we advise against using our aroma diffusers with distilled water, as it may interfere with the water level sensor. This can cause the diffuser to shut off incorrectly because it cannot accurately detect the water level.

Yes, Lucy has a battery with a running time of up to 7 hours. The battery must be fully charged for at least 6 hours before using it for the first time.

As soon as the LED on the back starts flashing, Lucy must be recharged. We recommend that you don’t use the aroma diffuser while it is charging so that the battery can be fully charged as quickly as possible.

Yes, the device will switch off automatically when there is no water left in the water container. Lucy will not be damaged if she runs out of water.

1. Unplug Lucy
2. Empty Lucy's water tank and rinse it out with warm water
3. Plug Lucy in again
4. Press and hold the LED button first, then also press the ON/OFF button
5. Hold both buttons for approximately 2–3 seconds
6. After that, the LED should flash 4×
7. Refill Lucy with water and switch her on again

We do not recommend using Lucy with distilled water – it can lead to malfunctions.

We recommend the use of pure natural essential oils for the operation of your aroma diffuser.

To begin with, you can add 2–3 drops of the scented oil to the water. Depending on the desired intensity of the fragrance, you can increase or decrease the number of drops. If you barely smell the scent, please look at the list with recommendations:

• Increase the amount of oil/fragrance drops in the diffuser
• Try different kind of fragrances/essential oils. How much the scent is noticeable depends mostly on the quality of the fragrance itself (synthetic, natural, ingredients, etc.). It is comparable with wine; quality is everything plus the scent also changes over time. Our experience is that the best results are achieved with 100 % pure essential oils of a high quality and concentration.
• The room temperature and relative air humidity influence how noticeable the scent is. The drier the environment, the less noticeable is the scent - A high rate of air ventilation (opening windows and/or heating/air conditioning) has a direct influence on the scent because it makes it disappear faster. Reducing the air ventilation and not putting the aroma diffuser next to an air vent helps to increase the time the scent remains in the air and thus the noticeability. This also means no tilted windows Make sure the aroma diffuser is positioned where you like the scent to be most noticeable, best at least 70 cm above the floor.
• Clean the inside of the aroma diffuser at least once a week and make sure to thoroughly clean the transducer from any oil/scent residues. The transducer can be clogged which results in a lower output and less noticeability of the scent
  Clean the inside of the aroma diffuser at least once a week or if you want to use a different fragrance. Make sure that the membrane is carefully cleaned of oil/perfume residues. Residues can clog the membrane, resulting in lower performance and reduced perceptibility of the fragrance